個人工具
您位於: 首頁 INCAM 系列軟體 INCAM-M25 INCAM-M25 英文說明 System Parameter

System Parameter

If users select System Parameter, parameter setting/simulation display area will show Edit page as shown in the figure below:

5.1 System_Para


For further information of System parameter→Header/Trailer, please click here.

Tool Change Code

Users can enter tool change code in this column. The system will export the codes set in this column automatically when tool changing is necessary. That is to say, if users did not set tool change code in this column, there will be no tool change code exported.

In addition to regular tool change code, the system also provides users with function variables settings on tool number, tool length, and spindle speed. Function variables is stated below.

Tool Number

%1

Tool Length

%2

Spindle Speed

%3

For example: the parameters of machining process 1 are set as follows: tool number is 1, tool length is 2mm, and spindle speed is 3000. Different tool change codes will export different results shown in the following.

Tool change code

Tool change code exported by the system

None (No tool change code)

None (No export)

M6T%1

M6T1

G49

M6T%1

G43H%2

M3S%3

G49

M6T1

G43H2

M3S3000

Feed Rate, Spindle Feed Rate

These two columns show the default values of spindle feed rate and cutting feed rate.

Step In Width (Radius %)

Users can set the widening width of pocket machining in this column. The width is calculated by tool radius and Step In Width ratio. There are four options (150%, 125%, 100%, 75%). Multiplying tool radius by the set ratio is Step In Width.

Step In Width = Tool Radius * Step In Width Ratio (150%, 125%, 100%, 75%)

Step In Width
文件動作